User Manual

i
HF IN button
Switches the HF band (high shelving) on/off.
j
HF FREQ knob
Adjusts the cutoff frequency of the HF band (high shelving).
k
HF GAIN knob
Adjusts the gain of the HF band (high shelving).
l
HMF IN button
Switches the HMF band (peaking) on/off.
m
HMF x3 button
Triples the center frequency value of the HMF band (peaking).
n
HMF FREQ knob
Adjusts the center frequency of the HMF band (peaking).
o
HMF GAIN knob
Adjusts the gain of the HMF band (peaking).
p
HMF Q knob
Adjusts the Q (steepness) of the HMF band (peaking).
q
TRANS. switch
Switches the type of input transformer that is emulated. You can choose a mic input transformer or a line input
transformer.
r
DRIVE knob
Adjusts the input level to adjust the amount of overtones. If the “DRIVE indicator” at the upper left of the DRIVE
knob is bright green, the overtone amount is appropriate.
s
LPF FREQ knob
Adjusts the cutoff frequency of the high pass filter.
t
HPF FREQ knob
Adjusts the cutoff frequency of the low pass filter.
u
ALL EQ button
Turns the LF/LMF/HMF/HF bands on/off together. (This does not affect HPF/LPF.) If the ALL EQ button is off, you
cannot use the LF IN, LMF IN, HMF IN, or HF IN buttons to turn individual bands on/off.
677
Plug-ins > Controlling the Rupert EQ 810 plug-in parameters