User Manual

Controlling the Rupert Comp 830 plug-in parameters
Rupert Comp 830 is a processor that emulates the compressor section built into the top recording consoles
developed by Rupert Neve during the 1980s. In addition to providing a broad range of control for Attack and
Release, this compressor provides an EQ and filter on the sidechain, giving you an extremely broad range of
tone-shaping possibilities, and letting you create nearly any sound. The compression is transparent and
smooth-sounding, and can be used on any source in any situation. By using VCM technology, this compressor
models a circuit with a further-evolved audio transformer by Rupert Neve. A shiny, colorful, and well-defined
sound can be obtained simply by routing the signal through this processor.
2 4
) ! @ #
$
%
1 3
7 8
5
9
6
^
a
HPF ON button
Toggles the sidechain’s high pass filter on/off.
b
HPF FREQ button
Adjusts the cutoff frequency of the sidechain’s high pass filter.
c
LPF ON button
Toggles the sidechain’s low pass filter on/off.
d
LPF FREQ knob
Adjusts the cutoff frequency of the sidechain’s low pass filter.
e
MF ON button
Toggles the sidechain’s MF band (peaking) on/off.
f
MF FREQ x10 button
Switches the sidechain’s MF band (peaking) center frequency to 10 times its value.
g
MF FREQ knob
Adjusts the sidechain’s MF band (peaking) center frequency.
h
MF GAIN knob
Adjusts the gain of the sidechain’s MF band (peaking).
690
Plug-ins > Controlling the Rupert Comp 830 plug-in parameters