User Manual

The TEMPO parameter has the following characteristics that are unlike other parameters.
• The TEMPO parameter can be shared by multiple effects.
• You cannot store it to or recall it from the Plug-in Library. (You can store it to and recall it from a scene.)
This means that the TEMPO value may not necessarily be the same when an effect is recalled as when that
effect was stored. Here is an example.
Store the effect: TEMPO=120 → Change TEMPO to 60: TEMPO=60 → Recall the effect:
TEMPO=60
Normally when you change the TEMPO, the DELAY (or FREQ.) will be re-set accordingly. However if the DELAY
(or FREQ.) were changed, the effect would sound differently when recalled than when it was stored. To
prevent the effect from changing in this way between store and recall, the RIVAGE PM series does not update
the DELAY (or FREQ.) value when an effect is recalled, even if the TEMPO is no longer the same as when that
effect was stored.
* The NOTE parameter is calculated based on the following values.
Label 1/32(3) 1/16(3) 1/16 1/8(3) Dot 1/16 1/8 1/4(3)
Value 1/48 1/24 1/16 1/12 3/32 1/8 1/6
Label Dot 1/8 1/4 Dot 1/4 1/2 Dot 1/2 Whole 2x Whole
Value 3/16 1/4 3/8 1/2 3/4 1/1 2/1
712
Plug-ins > Effects and tempo synchronization