User Manual

Assigning channels to the input/output of the recorder
Follow the steps below to patch the desired channels to the input and output of the USB memory recorder.
You can patch any output channel or the direct output of an input channel to the recorder’s input. You can
patch the recorder’s output to any input channel.
1 Press the RACK&REC button on the menu bar to access the RACK&REC screen.
This screen includes several pages, which you can switch between using the tabs located at
the top of the screen.
2 Press the USB RECORDER tab.
The “RECORDER screen”(p.735) appears.
3 To assign channels to the recorder’s input, press the RECORDER INPUT popup
button L or R.
The “INPUT PATCH popup window”(p.737) appears.
4 Use the category list and the channel select buttons to select the channel that you
want to patch to the USB memory recorder’s input.
If you select a channel to which a channel is already patched, a dialog box will ask you to
confirm the patch change. Press the OK button in the dialog box.
5 When you finish assigning the channel, press the CLOSE button.
The system will return to the RECORDER screen.
6 The system will return to the RECORDER screen.
7 Assign a channel to the other input in the same way.
NOTE
The USB memory recorder always records and plays back in stereo. If you want to record in monaural, with the same signal
for left and right, you must assign both of the recorder inputs to the same channel.
8 To assign channels to the recorder’s playback output, press the PLAYBACK OUT
popup button L or R.
The “OUTPUT PATCH popup window”(p.738)appears.
9 When you finish assigning the channels, press the CLOSE button.
The system will return to the RECORDER screen.
10 Assign a channel to the other output in the same way.
734
Recording > Assigning channels to the input/output of the recorder