User Manual

Recording or playing back using a DAW on the computer
Follow the steps below to record or play back using a DAW.
• Setting up the RIVAGE PM series
To perform a virtual sound check, configure the recording patches. Recording/playback signals should be
transfered from and received at HY card slot 4 on the DSP engine (or HY card slot 3 on the CSD-R7). If the
RPio622 or RPio222 signal is split out, you do not need to configure the patches. The signals will be output to
the Dante network directly from the HY144-D card inserted in HY slot 2 of the RPio622.
• Configuring Dante Accelerator or Dante Virtual Soundcard
Configure the Dante network and the computer.
• Setting up Dante patches
Use Dante Controller to configure Dante patches.
• Setting up for a DAW
Select Dante Virtual Soundcard, or AIC128-D ASIO driver.
NOTE
(
You must have a license ID to use a Dante Virtual Soundcard. The DVS token that is required for obtaining the license ID is printed
on a sheet (supplied in the HY144-D / HY144-D-SRC package).
(
The latest information about the Dante Virtual Soundcard and the Dante Controller is available at the following website:
(
http://www.yamahaproaudio.com/
744
Recording > Recording or playing back using a DAW on the computer