User Manual

Configuring Dante Controller
Connect the network port of the computer to a GbE-compatible network switch. Configure the computer to
obtain an IP address automatically (this is the default setting). You must make the following settings for
Dante Controller.
(
For multitrack recording: Patch audio signals from the I/O rack to the DVS or Dante Accelerator card for
multitrack recording.
(
For virtual sound check: Patch audio signals in such a way that they will be output from the computer to
the Dante audio network, then routed to the channels on the RIVAGE PM series (“Patching for multitrack
recording and virtual sound check”(p.741)).
The following example shows Dante Controller settings for when playback signals from Dante Accelerator are
patched to HY144-D card for a virtual sound check.
During multitrack playback, you can switch these settings easily using the VIRTUAL SOUND CHECK ON button
on the RECORDING PATCH screen.
NOTE
Please refer to the Dante Controller manual for more information about operations and settings of the Dante Controller.
747
Recording > Configuring Dante Controller