User Manual

9 If necessary, press the WITH OVERLAY APPLIED button.
A dialog box will appear.
CAUTION
(
While Overlay is enabled, if you recall a scene that was stored or globally-pasted with added offset values, both the current
offset values and the original offset values will be applied to the scene, thus, doubling the offset value.
10 Press the PASTE button.
The selected item(s) in the current scene will be pasted to the specified scene(s) in memory. A
progress bar will appear during the paste operation. Also, during the paste operation, a STOP
button will appear, which you can press to cancel the paste operation. In this case, data will be
pasted up until you press the STOP button. The operation cannot be reverted.
NOTE
(
In any of the following cases, a dialog box will appear and data will not be pasted:
(
You attempted to paste data to a protected scene.
(
(
The paste destination scene has been deleted by another operation (from PM Editor, etc.) just before the paste operation was
executed.
(
(
If pasting data to one of the paired channels causes the pairing setting to be canceled, the other channel from that pair will be set
to MONO.
802
Scene memory > Using the Global Paste function