User Manual

Loading a file from a USB flash drive

Follow the steps below to load the RIVAGE PM series setting file from the USB flash drive into the console.

You can use the same procedure to load the following files other than the setting file.

Extension Type Contents of file

.PM10ALL

.PM7ALL

ALL

All data including internal settings for the RIVAGE PM

series (the save format prior to V3.05)

.PM10PART

.PM7PART

Data including individual internal settings for the

RIVAGE PM series (the save format prior to V3.05)*1

.RIVAGEPM ALL

All data including internal settings for the RIVAGE PM

series

.RIVAGEPM *1

Data including individual internal settings for the

RIVAGE PM series *1

.BMP BMP

Image file for display in the CONSOLE LOCK screen

(256 or more colors, uncompressed bitmap format)

.jpg JPG

Image file for display in the CONSOLE LOCK screen

(JPEG format)

.png PNG

Image file for display in the CONSOLE LOCK screen

(PNG format)

*1 For more information about the type and file details, refer to the “TYPE field” in the section entitled

““Saving the RIVAGE PM series’s settings on a USB flash drive”(p.840)”.

(

Some data may contain settings that will cause the console to output signals immediately after the data is loaded. Therefore,

before loading data, turn off the power to the equipment connected to the control surface and/or lower the volume of such

equipment so that there will not be a problem even if a signal is output from the control surface.

845

File > Loading a file from a USB flash drive