User Manual

SURFACE SETTINGS2
This screen contains the following items.
a
AUTO CHANNEL SELECT field
Specifies whether the corresponding channel will be selected when you operate the [ON] key or fader for the channel.
This can be turned on/off separately for input channels and output channels.
b
USE FADER TOUCH
If this ON button is turned on, touching a fader will automatically select the corresponding channel via the Touch
Sense function built into the channel fader.
c
FADER TOUCH SENSITIVITY
Touch sensitivity can be adjusted in five steps. Higher values provide greater touch sensitivity.
d
[FADER BANK] > [SEL] LINK
Specifies whether channel selection will be linked with fader bank selection. You can set this parameter separately
for INPUT (input channels), OUTPUT (output channels), and CUSTOM (Custom fader bank). If this ON button is lit, and
you select the corresponding fader bank, the channel in that bank that was selected most recently will be selected,
and its [SEL] key will light. Changing the Bay Link setting will clear the position of the selected channel stored in each
layer.
e
DCA ROLL OUT
No. OF BAYS TO USE
Enables you to select whether the DCA will be rolled out to one bay or two.
879
User Setup > SURFACE SETTINGS2