User Manual

f
Fn KEYS ASSIGNMENT（CS-R10、CS-R10-S、CSD-R7）
Enables you to select one of the following functions to be assigned to each [Fn] key.
(
NONE...........................................No function will be assigned.
(
INPUT A/B...............................Switches between INPUT A and B.
(
ISOLATE...............................Channel Isolate ON/OFF
(
ALTERNATE CUE...............................If the CUE button is set to CUE A, B will be cued. If the CUE button is set to CUE
B, A will be cued. Nothing will happen if CUE button is set to A+B.
(
ENCODER PARAM...............................On/Off for parameters related to the channel strip encoders
(
SURROUND CUE..............................Surround Cue ON/OFF
(
GC ON/OFF.................... Gain compensation ON/OFF
(
EQ A/B ................................ Switches EQ parameters A and B
(
DYNAMICS1 A/B ................................ Switches Dynamics 1 parameters A and B
(
DYNAMICS2 A/B ................................ Switches Dynamics 2 parameters A and B
(
VSC ON.................... VSC ON/OFF
g
LED ASSISTANCE
PANEL ASSISTANCE
If this is turned on when the PANEL parameter in the BRIGHTNESS field is set to less than 50%, this will softly light all
LED indicators on the panel.
HIGHLIGHT NOMINAL POINTS
If this ON button is lit, the nominal value indication on the panel will be highlighted by the LEDs.
h
[ON] KEYS FUNCTIONS SOF
Selects the operation of the [ON] keys in SENDS ON FADER mode
NOTE
(
SEND ................... Send on/off
(
CHANNEL ........... Channel on/off
This is effective when the monitor engineer wishes to continually control the channel on/off, even in SENDS ON FADER
mode.
i
[ON] KEYS BEHAVIOR DURING MUTE
Selects the operation of the [ON] keys while muted.
(
OVERRIDE....................Disabled
(
CHANNEL OFF....................Enabled
j
[SEND SEL]>[CUE] LINK button
Turns on/off the following of CUE status in SENDS ON FADER mode when switching the master bus.
k
POPUP APPERARS WHEN KNOBS PRESSED button
If this button is turned on, a popup window for the appropriate function will open when you press the knobs in the
Selected Channel section on the panel. The touch screen (bay L, C, or R) that will display the popup window depends
on which Selected Channel section you select on the SURFACE SETTINGS1 tab.
880
User Setup > SURFACE SETTINGS2