User Manual

4 Use the buttons in the PROGRAM CHANGE MODE field to select the Program Change
transmission/reception mode.
You can select one of the following two Program Change transmission/reception modes.
・ Multi mode (when the MULTI button is on):
Program changes of all MIDI channels will be transmitted and received. (The transmit/receive
channel specified in the MIDI page will be ignored.) When a Program Change is received, the
scene assigned to the corresponding MIDI channel and program number in the list will be
recalled. When you recall a specified scene on the RIVAGE PM series, the Program Change of
the corresponding MIDI channel and program number in the list will be transmitted.
• Single mode (when the SINGLE button is on):
Only Program Changes of the transmit (Tx) and receive (Rx) channels specified in the MIDI
page will be transmitted and received. When a Program Change on the Rx channel is received,
the scene assigned to that program number of the corresponding channel in the list will be
recalled. When you recall a specified scene on the RIVAGE PM series, the Program Change of
the corresponding program number will be transmitted on the Tx channel shown in the list. (If
an event is assigned to more than one program number on the same channel, the lowest-
numbered program number will be transmitted.) If you turn on the OMNI button or BANK
button in Single mode, operation will change as follows.
• When the OMNI button is on:
Program changes of all MIDI channels will be received. However, regardless of the MIDI
channel that is received, the scene assigned to the corresponding program number of the Rx
channel will be recalled. Turning on the OMNI button will not change the operation for
Program Change transmission.
• When the BANK button is on:
The CH indication in the list will change to BANK (bank number), and Bank Select (Control
Change #0, #32) and Program Change messages can be transmitted and received. This can be
convenient if you want to control more than 128 scenes on a single MIDI channel. When Bank
Select and then Program Change messages (in that order) are received on the Rx channel, the
scene assigned to that bank number and program number in the list will be recalled. When
you recall a specific scene on the RIVAGE PM series, Bank Select and Program Change
messages for the bank number and program number assigned to that scene will be
transmitted on the Tx channel. (If the same scene is assigned more than once in the list, the
lowest-numbered bank number and program number will be transmitted.)
NOTE
The settings of the OMNI and BANK buttons are ignored in Multi mode. If the BANK button is on and only a Program Change
on an applicable MIDI channel is received, the last-selected bank number will be used. If the BANK button is on, the OMNI
button can also be turned on at the same time. In this case, Bank Select and Program Change messages of all MIDI channels
will be received.
5 Use the buttons in the PROGRAM CHANGE field to turn transmission and reception
on or off, and make settings for echo output.
933
MIDI/GPI > Using Program Changes to recall scenes