User Manual

6 To assign a scene to each program number, press the desired cell in the PROGRAM
CHANGE ASSIGNMENT column on the list.
The “MIDI PROGRAM CHANGE popup window”(p.936) appears. In this window, you can specify
the scene (to be recalled) that you want to assign to each program number.
7 Select SCENE in the TYPE field, and then use the LIST/DIRECT field to select a
desired scene number for recall operations.
To select an item, use the [TOUCH AND TURN] knob. Press the OK button to confirm the
change and close the MIDI PROGRAM CHANGE popup window.
NOTE
Alternatively, you can select a scene number by pressing the desired number in the field or by turning the corresponding
screen encoder.
8 Assign scenes to other program numbers in the same way.
With these settings, recalling a specified scene on the RIVAGE PM series will cause the
corresponding Program Change (or Bank Select and Program Change) messages to be
transmitted to an external device. When an external device receives Program Change (or Bank
Select plus Program Change) messages on the appropriate MIDI channel, the scene assigned
to that program number of the corresponding MIDI channel (or bank number) will be recalled.
NOTE
(
You can use the CLEAR ALL button to erase all assignments to program numbers.
(
Assignments to program numbers are maintained as settings for the entire system, rather than for individual scenes.
(
In Single mode, if the same scene is assigned to more than one program number on a Tx channel, only the lowest
program number will be transmitted. (If the BANK button is on, only the program number of the lowest bank number will
be transmitted.)
(
In Multi mode, if the same scene is assigned to more than one MIDI channel and more than one program number, only
the lowest program number on each MIDI channel will be transmitted.
934
MIDI/GPI > Using Program Changes to recall scenes