User Manual

Using GPI OUT
The GPI OUT ports of the GPI OUT connector enable you to control an external device by performing
operations on the RIVAGE PM series.
1 Connect an external device to the GPI connector of the control surface.
NOTE
If using the DSP engine, connect the DSP engine with the external devices. The subsequent explanation is for when using
the control surface.
2 Press the SETUP button on the menu bar to access the SETUP screen.
3 Press the MIDI/GPI [CS] button to open the MIDI/GPI [CS] popup window.
NOTE
If using the DSP engine, press the MIDI/GPI [DSP] button to access the MIDI/GPI [DSP] popup window.
This screen includes several pages, which you can switch between using the tabs located at
the top of the screen.
4 Press the GPI tab.
The view switches to the “GPI page”(p.949).
5 Specify the POLARITY MODE based on the specifications of the external device you
are using.
947
MIDI/GPI > Using GPI OUT