User Manual

Using FADER START
Make FADER START settings if you want a device connected to a GPI OUT port to operate in tandem with
fader operations.
1 Connect an external device to the GPI connector of the control surface or the DSP
engine.
NOTE
If using the DSP engine, connect the DSP engine with the external devices. The subsequent explanation is for when using
the control surface.
2 Press the SETUP button on the menu bar to access the SETUP screen.
3 Press the MIDI/GPI [CS] button to open the MIDI/GPI [CS] popup window.
NOTE
If using the DSP engine, press the MIDI/GPI [DSP] button to access the MIDI/GPI [DSP] popup window.
This screen includes several pages, which you can switch between using the tabs located at
the top of the screen.
4 Press the FADER START tab.
Switches the view to the “FADER START page”(p.951).
5 For each GPI OUT port, specify the channel that will cause the external device to
operate, and also specify the type of operation.
950
MIDI/GPI > Using FADER START