User Manual

NO ASSIGN

Operating the fader of the selected channel will not cause a signal to be output.

FADER START

A trigger signal of 250 msec duration will be output if the fader of the selected channel is raised from below the

specified UPSTROKE level (between −138.0 dB and 10.0 dB) to beyond that level.

FADER STOP

A trigger signal of 250 msec duration will be output when the fader of the selected channel reaches the specified

DOWNSTROKE level (between −∞ dB and 9.95 dB).

FADER TALLY

A trigger signal will be output if the fader of the selected channel is raised from below the specified UPSTROKE level

(between −138.0 dB and 10.0 dB) to beyond that level. This signal will be held until the fader reaches the specified

DOWNSTROKE level (between −∞ and 9.95 dB), or until that GPI OUT port receives a different trigger. The following

illustration shows how the output signal from the GPI OUT port will change when a fader is operated in each fader

mode. In this example, the THRESHOLD field is set to −60.00 for UPSTROKE, and to −∞ for DOWNSTROKE. (In this

illustration,

is selected as the POLARITY of the GPI OUT port. If POLARITY is selected, the output

signal polarity will be reversed.)

FADER

START

FADER

TALLY

FADER

STOP

250 msec

NOTE

At the high level, the output signal of the port will be open. If the receiving device requires high level, take it from the +5V

power supply pin. However in this case, there is a limit on the amount of current that can be provided. For details, refer to the

“Control input/output specifications” section in the data list.

SET BY SEL button

If this button is on, you will be able to add a channel by using the corresponding [SEL] key.

952

MIDI/GPI > FADER START page