User Manual

Adjusting the faders
Depending on the environment in which you use the system, discrepancies may occur in the motion of the
motorized faders. You can use the Calibration function to correct these discrepancies. The RIVAGE PM series
features two types of fader calibration.
Motor Drive Calibration Automatically optimizes the motorized fader movement.
Positioning Calibration
Calibrates the motorized fader movement so that the fader
knob positions and the level values stored in the console
(parameter) will match.
NOTE
An alarm message will appear if a problem is detected in the fader settings while the RIVAGE PM series is starting up.
1 Press the SETUP button on the menu bar to access the SETUP screen.
2 Press the MAINTENANCE button to access the MAINTENANCE popup window.
This window includes several pages, which you can switch between using the tabs located at
the top of the window.
3 Press the FADER CALIB tab.
The FADER CALIBRATION screen will appear, which will enable you to adjust the faders.
957
Maintenance > Adjusting the faders