User Manual

3 In SELECT MIXER TYPE, select the RIVAGE PM Series unit; and in NETWORK
INTERFACE, select the network that you will use.
If an IP address that can be connected to the selected network is specified, the Connect button
can be pressed.
4 Click the Connect button so that the RIVAGE PM series will be linked to PM Editor.
NOTE
If you plan to link channel block selection in PM Editor with that of console bay R, press [SETUP] -> [PREFERENCES] -> MISC
tab to access the LINK TO/FROM CONSOLE field, and then set FADER BANK SEL (BAY R) to “on”.
Once the DSP engine detects PM Editor on-line, the DEVICE SYNC screen appears.
When connecting PM Editor, you must specify the data sync direction for the DSP engine.
5 Select “EDITOR ← DSP.”
6 Press the SYNC button.
Parameter settings on the RIVAGE PM series will be copied to PM Editor. Once data
synchronization is completed, the line indicating synchronization is displayed in green.
985
Setting up RIVAGE PM Editor and RIVAGE PM StageMix > On-line monitoring/operation