User Manual

12
9.
When the HY144-D is detected, click the [Stop Scan] button.
If several minutes have passed without detection, use Dante Controller to check whether the cable might be
disconnected or broken, whether the TCP/IP settings are correct or not, and whether the device which is installed
the HY144-D is running or not.
10.
Select the check box of the detected HY144-D.
11.
Click [Start].
A pop-up is displayed confirming that you wish to proceed.
12.
Click [OK] to start the recovery.
Firmware Update Manager will display "Processing Safe Recovery", and then "Safe Recovery Done" when the
device(s) are recovered.