User Manual

RPio222 Owner’s Manual
8
Front Panel
1 Color Indicator
Indicates the status of the unit.
Refer to the Message List (page 17) for more
information on errors.
2 LCD
Indicates the setting parameters for the unit.
3 [MENU] key
The following setting parameters are indicated on the
LCD:
4 [U]/[D] keys
Enable you to select a setting parameter or value.
5 [ENTER] key
Confirms the setting parameter or the value.
6 [+48V MASTER] switch
This is the master switch for the unit’s +48V phantom
power supply.
If the [+48V MASTER] switch is off, no phantom
power will be supplied to the unit’s input connectors
even if phantom power to individual channels is
turned on.
Part Names & Functions
132 4
5
6
8 9
7
This figure illustrates the rack with various RY cards already installed.
Red
(flashing)
A critical error has occurred.
Yellow
(lit steadily)
Indicates a minor issue, but you can
continue using the unit.
Green Normal
Unit ID Specifies the Unit ID for the unit. You must
set a unique ID for each device connected
to the same I/O network so that they will be
identified correctly.
For more information on setting the Unit ID,
refer to “Setting the Unit ID” in the RIVAGE
PM10 System Setup Guide.
Fan Spd Specifies the speed of the cooling fans on
the unit.
This setting does not affect the speed of
the cooling fans on the power supply units.
Brightns Adjusts the brightness of the LCD.
Contrast Sets the contrast of the LCD screen.
FaultOut Specifies the conditions under which an
indication of abnormality is sent from the
[FAULT OUTPUT] connector.
Red: An indication of abnormality is sent if
an error occurs that causes the color
indicator to flash red.
Y&R: An indication of abnormality is sent if
an error occurs that causes the color
indicator to light up yellow steadily or flash
red.
F/W Ver. Indicates the current firmware version
number of the unit.
Initialz Initializes the unit.
[+48V MASTER]
switch
Channel
phantom power
Channel +48V
indicator
On
On
Light up
steadily
Off Flash
On
Off Dark
Off