User Manual

7
■ Updating the Dante firmware
For instructions on updating the Dante module firmware integrated in the HY144-D, see the steps
described below in the sections "When Using the Dante Firmware Update Manager" and "When Using
the Dante Updater." Dante Updater is installed automatically when you install Dante Controller.
・Perform the update with the HY144-D installed to the DSP-R10/DSP-RX/DSP-RX-EX HY card slot 3/4, to the CSD-R7
HY card slot 2/3 or to the RPio622/RPio222.
When Using the Dante Firmware Update Manager
1. Connect the Dante [PRIMARY] connector of the HY144-D to the Ethernet connector on the computer
using an Ethernet cable.
Be sure to directly connect the computer and the HY144-D, and do not connect any other Dante device
to the computer.
2. Turn on the power to the device to which the HY144-D is installed.
3. Windows: Select [Start]→[Audinate]→[Dante Firmware Update Manager]→[Dante Firmware Update
Manager] , then right-click and select “Run as Administrator.”
Mac: [Application]→[Dante Firmware Update Manager], then double-click “Dante Firmware Update
Manager.”
The Dante Firmware Update Manager will start up.
Check that the version number is 1.3.2 or higher from the title bar.
・The "User Account Control" dialog box may appear. Click [Continue] or [Yes].
・Dante Firmware Update Manager does not work with macOS 10.15 or later. Use Dante Updater installed with
Dante Controller.
4. If you see the interface selection screen, select the interface card to connect the Dante device.
5. Click [Update Dante Firmware].
6. Click [Browse] and select “FWUpdate_HY144-D_vxxx_swyyy.dnt,” then click [Open].
xxx and yyy represent the firmware version number.
・The Dante firmware will not work correctly if the path contains any characters other than single-byte
alphanumeric characters, "-" (hyphen), or "_" (underscore). You must save the firmware update file in a
directory whose name contains only single-byte alphanumeric characters, "-" (hyphen), or "_" (underscore). (E.g.,