User Manual
Table Of Contents
- 1. About the RIVAGE PM Network Setup Guide
- 2. Control Network Setup (RIVAGE PM Editor/RIVAGE PM StageMix/MonitorMix)
- 3. Dante Network Settings
- FAQ
- Q. Can two RIVAGE PM Editor apps be connected to one NETWORK [PC] connector?
- Q. When connecting multiple Dante networks with different physical connections to multiple HY144-D cards, can all the networks be set with their link-local address?
- Q. When connecting multiple Dante networks with different physical connections to multiple HY144-D cards, can all the networks be set with their link-local address?
- Q. The DANTE SETUP options in SYSTEM CONFIG are grayed out and cannot be edited. How can I make the settings?
- Q. Is it possible to segment a switch into a Dante network and a control network using a VLAN and connect the two networks to one switch?
17
To set up SLOT IP
The SLOT IP settings are for control communications between the HY144-D/-SRC and the
DSP engine. To remotely control a supported device, adjust the SLOT IP settings.
1. Press the SETUP button in the menu bar to access the SETUP screen, and then press
the SYSTEM CONFIG button.
2. Press the HY SLOT tab where an HY144-D/-SRC card is installed to display the HY
SLOT window.