User Manual
Table Of Contents
- PRECAUTIONS
- Contents
- Introduction
- System Overview
- About Dante
- About Connections
- Part Names & Functions
- Power Supply
- Installing and Removing Optional Cards
- Touch Screen
- Quick Guide
- Basic system configuration
- Installing an optional card
- Setting the Unit ID
- Connecting the devices
- Turning on the power to the RIVAGE PM10 system
- Setting the word clock
- Assigning channels to the TWINLANe network
- Patching the input ports
- Patching the output ports
- Setting the analog gain for HA (Head Amp)
- Sending an input channel signal to the STEREO bus
- Check list
- Other Operations
- Troubleshooting
- Specifications (CS-R10, CS-R10-S)
- Index
RIVAGE PM10 System Setup Guide
40
Assigning channels to the
TWINLANe network
On the DSP engine and I/O rack, you can select channels
to be output to the TWINLANe network, and make
settings to reserve certain bandwidth on the network.
1. Press the SYSTEM CONFIG button in the
SETUP screen.
2. Press the DSP button.
The SYSTEM CONFIG [DSP] popup window will
appear.
3. Press the Channel assign popup button.
For this example, select STEREO.
The TWINLANe CONFIGURATION popup
window will appear.
4. Press the channel select buttons to turn them
on.
For this example, select STA L and STA R.
Channel select button
5. To close the TWINLANe CONFIGURATION
popup window, press the CLOSE button.
The system will return to the SYSTEM CONFIG
[DSP] popup window.
6. If you changed the channel assignments,
press the APPLY button.
The setting will be applied to the output from the
DSP engine to the TWINLANe network.
7. When a confirmation dialog appears, press
the OK button.
8. To close the DSP engine setting screen, press
the “x” symbol located in the upper right.
The system will return to the SYSTEM CONFIG
popup window.
9. Select the I/O rack.
Press the I/O rack select button (in this example, the
M1 button).
The I/O rack settings popup window will appear.
Unselected Currently
selected
Already
selected