User Manual
Table Of Contents
- PRECAUTIONS
- Contents
- Introduction
- System Overview
- About Dante
- About Connections
- Part Names & Functions
- Power Supply
- Installing and Removing Optional Cards
- Touch Screen
- Quick Guide
- Basic system configuration
- Installing an optional card
- Setting the Unit ID
- Connecting the devices
- Turning on the power to the RIVAGE PM10 system
- Setting the word clock
- Assigning channels to the TWINLANe network
- Patching the input ports
- Patching the output ports
- Setting the analog gain for HA (Head Amp)
- Sending an input channel signal to the STEREO bus
- Check list
- Other Operations
- Troubleshooting
- Specifications (CS-R10, CS-R10-S)
- Index
RIVAGE PM10 System Setup Guide
48
Please visit the Yamaha Pro Audio website for a list of
frequently asked questions (FAQ).
https://www.yamaha.com/proaudio/
Power does not turn on.
❍ Make sure that the power switches are turned ON.
❍ Make sure that the AC power cords are connected.
➥ If the power still does not turn on, contact your Yamaha
dealer.
The unit is not receiving an audio input signal.
❍ If you are using an optional card, make sure that it is
installed properly.
❍ Make sure that the cables are connected properly.
❍ Make sure that the [ON] key indicator of the input
channel lights steadily.
❍ Make sure that the fader of the input channel is raised.
❍ Make sure that the input ports are patched correctly.
❍ Make sure that the channels are assigned to the
TWINLANe network correctly.
Sound is not loud enough.
❍ Make sure that the head amp gain is set to an
appropriate level.
❍ Make sure that the digital gain is set to an appropriate
level.
❍ Make sure that the fader of the input channel is raised.
❍ Make sure that the fader of the output channel is raised.
❍ Check the levels on the METER screen.
Sound is distorted.
❍ Make sure that the word clock is set correctly.
❍ Make sure that the head amp is set correctly.
❍ Make sure that the fader of the input channel is not
raised too high.
❍ Make sure that the fader of the output channel is not
raised too high.
Touch screens, LEDs and/or lamps are not bright
enough.
❍ The brightness parameter on the SETUP screen may be
set too low.
In the LCD display, there are some dots that are
always dark or always lit.
❍ This is a common property of color LCD, not a
malfunction.
Troubleshooting