User Manual

DSP-RX(-EX) Owner’s Manual

Euroblock Plug Connection

You must use the supplied Euroblock plug to connect to

the FAULT OUTPUT connector.

1. Loosen the terminal screws.

* The following explanation uses a Euroblock plug that

features a tab as an example.

NOTE

Use a slotted screwdriver of 3 mm or less.

2. Insert the cables.

3. Securely tighten the terminal screws.

Pull the cables (not too strongly) to confirm that they

are securely connected.

4. Affix the cables to the tab using the supplied

cable binder.

NOTE

After affixing the cables, you can cut off the unnecessary

part if you prefer.

5. Insert the Euroblock plug into the FAULT

OUTPUT connector on the rear panel on the

unit.

Preparation (Cable preparation)

• Use strand wires for the Euroblock plug. First, strip

the strand wire insulation as shown below. After the

strand wires are connected to the Euroblock plug,

the wires may break due to metal fatigue caused by

the weight of the cable or vibration. For a rack

mount, use wire binding bar if possible, to bind the

wires together and secure them.

• If you plan to connect or disconnect the plug often,

for example in mobile installations, we recommend

that you use a rod terminal jack with insulating

sleeves. Be sure to use a rod terminal jack that

features a conducting part with an outer diameter of

1.6 mm or less, and a length of approx. 7 mm (such

as AI 0,5 - 6 WH by Phoenix Contact).

Approx. 7mm

Approx. 20mm

Approx. 7 mm

1.6 mm or less

Loosen

Slotted Screwdriver

Terminal Screw

Euroblock Plug

Tab

3 mm or less