User Manual

13.

Exit the Dante Firmware Update Manager, and wait for two minutes before turning off the power to

the device to which the HY144-D is installed.

After recovery, restart the Dante module. If you power-off the device to which the HY144-D is installed before

restart is completed, the data of the Dante module will be corrupted, and you will have to perform the recovery

once again. Start Dante Controller, and if the device name is shown in black, it is safe to turn off the power.

14.

The correct Dante firmware now needs to be loaded.

After recovery, the Dante firmware will not be the latest version. To update to the latest firmware, perform steps 2

through 11 of "Updating the Dante firmware." At this time, also perform “Check the [Override Device Matching]”

in step 7.

Now recovery and firmware update are completed.

Manual Development

Group

Published 02/2018 YJHH -A0