User Manual

DSP popup window
3
4
6
8
9
7
)
2
1
5
7
8
This screen contains the following items.
a
DSP engine indicator
This button represents the DSP engine that is connected to the system. The row at the top of the button shows the
power supply status of POWER A and B (green: power on, red: power off). The device icon indicates the device status
(green: normal; yellow: abnormal, red: critical error).
b
HY SLOT select buttons
These buttons allow you to select the HY SLOT (TWINLANe network) for which you will assign channels. (You can
select only HY SLOT1 for the CSD-R7.) The optical reception power status and value on the TWINLANe network are
also shown here.
HY SLOT1 is for the main network, and HY SLOT2 is for the sub network.
Green: Normal
Yellow: Optical reception power is getting low.
Red “LOW”: Optical reception power is too low to communicate.
It also indicates the type of HY cards (MMF:HY256-TL; SMF:HY256-TL-SMF) and the total length of the cables.
c
Display switch buttons for the channel assign popup button area
These buttons enable you to select which channels will be assigned to the TWINLANe: either output bus/direct out or
insert out.
d
Channel assign popup buttons
When you press a button, a TWINLANe CONFIGURATION popup window appears, in which you can assign the direct
out to the TWINLANe network.
The number of channels varies depending on the system configuration. (Refer to page xx.)
238
System Setup > DSP popup window