User Manual

c
Channel strip encoder display
Indicates the function that has been assigned to the channel strip encoder.
d
UP [@U@]/DOWN [@D@] keys
Enable you to select the function that you want to control using the channel strip encoder.
e
[SHIFT] key
Combine with another key to perform certain functions. For more information, refer to the Special Key Command List
for the RIVAGE PM Series.
f
[SENDS ON FADER] key
Turns SENDS ON FADER mode on and off.
g
INPUT [1-72]/[73-144] keys
Enable you to select an input layer.
NOTE
Press the INPUT [1-72] key and INPUT [73-144] key simultaneously to select the INPUT 145-288 channel layer. Press these two
keys simultaneously again to select the INPUT 1-144 layer.
h
OUTPUT [MIX]/[MATRIX] keys
Enable you to select an output layer.
i
[DCA] key
Enables you to select a DCA layer.
j
CUSTOM [1]/[2] keys
Enable you to select a custom layer. You can assign up to five banks of custom faders to each custom layer (total of 60
layers). The CUSTOM [1] and [2] keys enable you to directly access two of these banks. Press CUSTOM [1] and
CUSTOM [2] together to enter Custom mode, where you can assign custom faders and access the rest of three banks.
k
Layer display
Indicates the selected layer.
l
Layer Select [A]/[B]/[C]/[D]/[E]/[F] keys
Enable you to select a layer.
m
[HOME] key
Recalls a group of settings. Press and hold down this key to store the following settings:
• Current screen
• Selected channel/parameter on the screen
• Selected layer
65
Part Names & Functions (CS-R10, CS-R10-S, CSD-R7) > [TOUCH AND TURN] knob/layer selection