User Manual

CONTENTS
Expanded SENDS ON FADER mode function
10 RIVAGE PM series V2.2 Supplemental Manual
■ About SEND SEL-CUE link
In SENDS ON FADER mode, the cue was switched accordingly when you switched the master bus.
You can now turn this function on or off.
PREFERENCES popup screen
1 [SEND SEL].>[CUE] LINK button
■ About the SENDS ON FADER popup window
You can now adjust the send levels without opening the SENDS ON FADER popup window, if you
engage SENDS ON FADER by pressing and holding down the [SHIFT] key and pressing the
[SENDS ON FADER] key.
CUE A, CUE B, and TALKBACK2 have been added as monitor sources that can be assigned to the
MONITOR SOURCE DEFINE buttons. (TALKBACK2 is a talkback signal on the control surface
that has its CONSOLE ID set to “2”.)
In this way, you can mix and monitor CUE A, CUE B, TALKBACK 1, or TALKBACK 2 along with
other monitor sources. This is convenient if you are using an IEM or back-talk mic (communication
mic from the performer to the engineer).
MONITOR SOURCE SELECT popup window
NOTE
If CUE is selected as the monitor source, we recommend that you turn off the CUE INTERRUPT
button so that the monitor source signal will not be interrupted by the CUE operation.
The new CUE INTERRUPT button for the PHONES settings now enables you to turn INTERRUPT
off. You can also assign this button function to a USER DEFINED key.
Expanded SENDS ON FADER mode
function
1
Additional CUE monitor sources