User Manual

CONTENTS
Supporting a new HY128-MD card
5 RIVAGE PM series V2.2 Supplemental Manual
3 SPLIT button
Specifies whether or not the input signal should be split and sent to the output connectors. The
signal will be sent to the same type of output connectors.
•ON
The input signal is split and sent to the output connectors.
•OFF
The input signal from the mounted card is output without being split.
4 INPUT SRC button
Turns the SRC for MADI input signals on or off.
5 SRC CLOCK buttons
Enable you to select the input signal clock when the SRC is turned on.
• MADI IN
Selects the MADI IN clock as the SRC’s input clock.
•WCLK IN
Selects the WCLK IN FOR SRC clock as the SRC’s input clock.
6 Fs indicators
Show whether the input signal is 48 kHz or 44.1 kHz. If a valid MADI signal is not being
input, neither indicator will light up.
7 RATE buttons
Enable you to select whether the MADI input signal will be processed as 1Fs, 2Fs, or 4Fs.
•1Fs
44.1 kHz/48 kHz, up to 64 channels
•2Fs
88.2 kHz/96 kHz, up to 32 channels
•4Fs
176.4 kHz/192 kHz, up to 16 channels
8 FRAME indicators
Show the input signal’s frame format. If a valid MADI signal is not being input, neither
indicator will light up.
9 CHANNEL FORMAT indicators
Show the channel format of the input signal. If a valid MADI signal is not being input, neither
indicator will light up.
) OUTPUT SRC button
Turns the SRC for MADI output signals on or off.
! SRC CLOCK buttons
Enable you to select the output signal clock while the SRC is turned on.
• MADI IN
The output signal will use the clock that is being input at the corresponding MADI IN
connector.
•WCLK IN
The output signal will use the clock that is being input at the WCLK IN FOR SRC connector.
@ OUTPUT FRAME buttons
Enable you to select the output signal’s frame format.
•SAME AS INPUT
The same format as the MADI IN signal will be used for the output signal. If a valid MADI
signal is not being input, the signal of the 48 k frame format will be output.
• 96k
The signal of the 96 k frame format will be output.
• 48k
The signal of the 48 k frame format will be output.
# OUTPUT CHANNEL FORMAT buttons
Enable you to select the output signal’s channel format.
•SAME AS INPUT
The number of the output signal will be the same as that of the MADI IN signal. If a valid
MADI signal is not being input, the 64-channel signal will be output.
•64
The 64-channel signal will be output.
•56
The 56-channel signal will be output.