User Manual

About connecting a computer
You can connect a computer with PM Editor installed to a DSP engine. To do so, connect the computer to the
NETWORK connector [PC] located next to the TO CONSOLE connector. Do not connect it to the NETWORK
connector located above the HY card slots. Alternatively, you can use the NETWORK connector on the control
surface. However, in this case, please note that the computer will be unable to communicate with the DSP
engine if the power to the control surface is turned off.
DSP Engine
Control Surface
CSD-R7
CS-R10
DSP-R10
Console Network
DSP Engine
Control Surface
If you want to connect two computers to a DSP engine or control surface, use a switching hub to make
connections.
213
Network and Connections > About connecting a computer