User Manual

Editing the internal parameters of the MY CARD OUTPUT
7
1
2
4
5
6
3
This screen contains the following items.
a
Patch indication
Indicates the channel that is patched.
b
DELAY button
Switches the output delay on or off.
c
Delay time knob
Sets the delay time of the output port. If you press this knob when it is selected, the DELAY TIME popup window will
appear. The delay time value is shown above the knob in millisecond units, and below the knob in the units that are
selected in the DELAY SCALE popup window.
NOTE
If the scale is set to ms, the delay time value above the knob will not be shown.
d
PHASE button
Switches the phase of the signal that is output.
e
GAIN knob
Adjusts the output gain of the output port. Use the screen encoder to adjust the value. Adjust the setting in 1.0 dB
units by turning the knob, or adjust the setting in 0.1 dB units by turning the knob while pressing it. The current value
is shown immediately below the knob.
f
Level meter
Indicates the output level of the signal after level adjustment.
270
System Setup > Editing the internal parameters of the MY CARD OUTPUT