User Manual

[SYSNC] Indicators Meaning Possible Solution
LightLight or
flash
A non-GbE-compatible device is
connected.
When transferring audio via Dante, use
device that supports GbE.
Light or
flash
Flash
The [SECONDARY] connector has taken
over communications during redundant
network operation.
Check the circuit connected to the
[PRIMARY] connector.
Light or
flash
Flash x2
An abnormality has occurred on the
circuit connected to the [SECONDARY]
connector during redundant network
operation.
Check the circuit connected to the
[SECONDARY] connector.
Information Messages
The indicators will remain lit and/or flashing cyclically to report the status. If the orange [SYNC] indicator is
unlit, the unit is operating normally. If the green [SYNC] indicator is unlit, the unit’s clock is unconfirmed.
[SYSNC] Indicators Meaning Possible Solution
Light
Synchronizing on Dante network
Please wait until started has completed
or until the unit has finished
synchronization. It may take up to 45
seconds for completion.
Waiting to receive setting data
If START UP MODE is set to REFRESH on
the R-series unit, the input/output will
be muted until the unit receives setting
data after it starts up.
308
System Setup > Dante messages