User Manual

Using the Cue function
This section explains how to use the [CUE] key of a desired channel or DCA to monitor the Cue signal.
NOTE
Be aware that if you turn CUE INTERRUPTION off in the MONITOR SETTINGS popup window, the cue signal will not be sent to the
connected monitor speakers. However, the PHONES output jacks on the front panel will always output cue signals regardless of the
Monitor on/off setting. For details on the Monitor function settings, refer to “Using the Monitor function”(p.388).
1 Press the MONITOR button on the menu bar.
The “MONITOR screen (cue)”(p.415) appears. The CUE field on the MONITOR screen enables
you to check the current cue settings, and turn Cue on or off.
2 Press the CUE popup button or the INPUT/DCA/OUTPUT CUE field.
The “CUE popup window”(p.417) appears.
3 Press the CUE SETTINGS popup button.
The “CUE SETTINGS popup window”(p.420) appears. You can select the cue destination (CUE
A, CUE B, or A+B).
4 Use the CUE MODE buttons to select either the mode in which channels are mixed
for monitoring, or the mode in which only the last-selected channel is monitored.
Select the MIX CUE button or LAST CUE button.
NOTE
In MIX CUE mode, it is not possible to simultaneously turn on Cue for different Cue groups. The Cue group to which the last-
cued signal belongs will be turned on, allowing only the signals of that Cue group to be monitored. However, if CUE
OPERATION MODE is set to BAY and if LAST CUE is selected, the cue setting in each bay will be active individually.
5 Use the buttons and knobs of the INPUT CUE field, DCA CUE field, and OUTPUT CUE
field to specify the output position and output level for each Cue group.
Refer to the explanation for each item in the “CUE popup window”(p.417), and make the
desired settings.
6 To specify a port as the output destination for cue signals L and R, press one of the
CUE OUTPUT PATCH buttons (L/R).
The “OUTPUT PATCH popup window”(p.421) appears. Choose from the following cue signal
output destinations (multiple selections are allowed).
When you have selected output ports, press the CLOSE button to close the CUE OUTPUT
PATCH popup window.
7 To enable Cue Out for the ports you specified in step 4, press the CUE OUTPUT
button to turn it on.
413
Monitor > Using the Cue function