User Manual

CSD-R7

LAMP jacks

These 4-pin female XLR output connectors are used to supply power to Yamaha LA1L gooseneck lamps supplied with

the unit (CS-R10, CSD-R7: 4 jacks; CS-R10-S: 3 jacks).

MIDI OUT/IN jacks

These connectors are used to transmit and receive MIDI messages to/from external MIDI devices.

GPI connector

This is a D-sub 25-pin female connector that allows communication (8-in, 8-out) with a GPI-equipped external device.

[FAN] switch

Sets the internal cooling fan to operate at either HIGH or LOW speed.

NOTE

This switch is set to LOW when the unit is initially shipped from the factory. As long as the unit is operated within the specified

ambient temperature range either the LOW or HIGH setting can be used. The HIGH setting is recommended if the ambient

temperature is high, if the unit is in direct sunlight even if the ambient temperature is within the specified operating range,

and in any situation in which fan noise is not a problem.

VIDEO OUT connector

Connect your external display monitor (XGA 1024x768 or higher) to this DVI-D (Dual-link) connector.

[RESET] switch

Resets the control surface. Only the controls (screens, indicators, and control keys and knobs) on the control surface

will restart without interrupting audio. Use this switch in case the control surface becomes non-responsive to your

operations.

OMNI IN jacks

These are balanced XLR-3-31 female input jacks for inputting analog audio signals from line level devices or

microphones. They feature SILK digital processing.

Part Names & Functions (CS-R10, CS-R10-S, CSD-R7) > Rear panel of the control surface