User Manual

Outputting a control signal to an external device in
tandem with scene recall (GPI OUT)
A control signal can be output to an external device connected to the GPI connector of the RIVAGE PM series
when you recall a specific scene. Proceed as follows.
NOTE
For more information about GPI OUT settings, refer to “Using GPI OUT”(p.947).
1 Press the SCENE field on the menu bar to access the SCENE LIST screen.
2 Press the GPI tab at the top of the SCENE LIST screen.
The “GPI field”(p.796) appears in the right half of the SCENE LIST screen.
3 Press the GPI SET popup button to access the SCENE SETUP (GPI) popup window.
4 For each scene, specify the control signal that you want to output to each GPI OUT
port.
Pressing a button repeatedly will switch between the following functions.
•‒‒‒‒ (OFF).....................Nothing will be output.
• TRIGGER.....................A trigger will be output when the scene is recalled.
• TALLY.....................A tally will be output when the scene is recalled.
5 When you finish making settings, press the OK button.
The setting will be finalized, and the popup window will close. If you press the CANCEL button
instead of the OK button, your changes will be discarded and the popup window will close.
NOTE
Scenes for which the GPI settings are made are marked by a “TALLY” or “TRIG” indicator in the GPI PARAMETER display
section of the SCENE LIST window (GPI tab).
6 Press the GPI button to enable the GPI OUT function.
You can turn the GPI OUT function on or off individually for each scene.
794
Scene memory > Outputting a control signal to an external device in tandem with scene recall (GPI OUT)