User Manual

FADER START page
1
2
8
4 5 6 7 3
The screen contains the following items.
■ OUTPUT DESTINATION field
a
GPI OUT1 – GPI OUT8 buttons
Select the GPI OUT port for which you want to make settings.
b
Fader indicator
Indicates the selected fader. Use the [SEL] keys on the panel to select a fader.
■ THRESHOLD field
c
UPSTROKE/DOWNSTROKE knobs
These knobs specify the level that will be the threshold at which to output a trigger signal. A trigger signal will be
output when the fader exceeds the UPSTROKE level, or when the fader falls below the DOWNSTROKE level.
Alternatively, you can use the [TOUCH AND TURN] knob.
NOTE
The THRESHOLD values specified by the UPSTROKE/DOWNSTROKE knobs are common to all channels (faders) and GPI OUT
ports. However, you can individually choose the channel (fader) for each GPI OUT port. Only the UPSTROKE value will be valid
if MODE is set to FADER START, and only the DOWNSTROKE value will be valid if MODE is set to FADER STOP. If MODE is set to
FADER TALLY, both the UPSTROKE and DOWNSTROKE values will be valid.
■ MODE field
Here you can select the mode of fader operation that will be the trigger for signal output from the GPI OUT
port. You can choose from the following fader modes.
951
MIDI/GPI > FADER START page