User Manual

g
Strip encoder
You can use the Screen Encoder function and the Channel Encoder function for channel strips 1–12. Use the ap.91 to
toggle between these two functions. You can use only the Channel Encoder function for channel strips A and B.
(
Screen Encoder function:
Up to 12 parameters can be assigned by selecting controls on the screen.
(
Channel Encoder function:
Adjusts the gain, pan, and the other parameters of the channel. The parameters for the selected function will be
assigned to the knob. Use the ap.91 to switch the parameters. See bChannel Strip Encoder for more information
regarding the available parameters.
h
[SEL] key
Enables you to select the channel that will be controlled in the Channel Strip section or on the display. When the
channel is selected, the key LED will light.
i
[ON] key
Switches the channel on or off. If the channel is on, the key LED will light. If the channel is in a mute group, the key
indicator will flash. In SENDS ON FADER mode (see f p.91), this key works as an on/off switch for signals sent from
each channel to the currently-selected MIX/MATRIX bus.
j
Fader
This is a touch-sensitive 100 mm motorized fader. In SENDS ON FADER mode, this fader adjusts the send level of the
signal sent from each channel to the currently-selected MIX/MATRIX bus.
k
[CUE] key
Selects the channel for cue.
l
Channel name display
Indicates the channel name, fader value, etc.
m
Channel color indicator
Indicates the channel color.
n
LED gain reduction （CS-R5 only）
Indicates the gain reduction.
o
LED meter
Indicates the channel level.
96
Part Names & Functions (CS-R5,CS-R3) > Channel Strip section