User Manual

3 Use the screen encoders to set the following parameters.
• BANK A–D..................Enable you to select the target bank (A–D).
CONTRAST field
• NAME............................Adjusts the contrast of the characters in the channel name
display on the top panel.
BRIGHTNESS field
• NAME............................Adjusts the brightness of the channel name displays on the top
panel. This will also change the CH COLOR brightness. If you want to adjust the CH COLOR
brightness after setting the name display brightness, use the CH COLOR knob.
• CH COLOR............................Adjusts the brightness of the channel colors on the top panel.
This lets you apply a relative adjustment to only the channel color brightness without
changing the channel name display brightness.
• PANEL...........................Adjusts the brightness of the top panel LEDs.
• SCREEN...........................Adjusts the brightness of the touch screens. If you have set the
brightness to lower than level 2, the system will start up next time with a brightness setting of
2 so that you will be able to see the screen.
• LAMP...........................Adjusts the brightness of the lamps connected to the rear panel LAMP
jacks.
4 If desired, switch among banks A–D, and make settings for the other bank in a
similar manner.
Now you can switch among the BANK A–D buttons to change the brightness of the touch
screens, LCDs, channel name displays, and lamps in a single operation. You can also assign
this parameter to a USER DEFINED key, and press that key to switch among banks A–D.
976
Panel Settings > Specifying the brightness of the touch screens, LEDs, channel name displays, and lamps