User Manual

HY144-D-SRC Firmware Update Guide 6
Described below are the procedures to update
the Dante module firmware integrated in the
HY144-D-SRC.
NOTE
Perform the update with the HY144-D-SRC installed in the slot of
a compatible device.
1. Connect the Dante [PRIMARY] connector
of the HY144-D-SRC to the Ethernet
connector on the computer using an
Ethernet cable.
Be sure to directly connect the computer
and the HY144-D-SRC, and do not connect
any other Dante device to the computer.
2. Turn on the power to the device to which
the HY144-D-SRC is installed.
3. Windows: Select [Start]→[All programs]
or [All apps]→[Audinate]→[Dante
Firmware Update Manager]→[Dante
Firmware Update Manager] , then right-
click and select [Run as Administrator].
Mac: [Application]→[Dante Firmware
Update Manager], then double-click
“Dante Firmware Update Manager.”
The Dante Firmware Update Manager will
start up. Check that the version number is
3.10.4.6 or higher from the title bar.
NOTE
The “User Account Control” dialog box may appear. Click
[Continue] or [Yes].
Updating the firmware