Manualshelf

User Manual

ManualsBrandsYamaha ManualsProfessional Audio MixersRIVAGE PM7
12345678910
CONTENTS
Software requirements
4 RIVAGE PM StageMix User Guide
• Apple iPad Air or later
• Supported OS: iOS11 or later, iPadOS
• Yamaha RIVAGE PM Series Digital Mixing System V4 or later
• Wi-Fi access point
• Ethernet cable (used to connect the RIVAGE PM system to the Wi-Fi access point)
Wi-Fi setup
Refer to the instruction manual for your device to set up the Wi-Fi access point. Although no special settings are required, we recommend that
you configure security settings, such as WPA, to prevent any outside intrusion into the network.
Network setting for the RIVAGE PM system
1. Use an Ethernet cable to connect the network port of the RIVAGE PM system to the Wi-Fi access point.
If you plan to connect it to a legacy access point that does not feature the AUTO-MDIX function, you will need to use a cross cable. Since
many newer device models support the AUTO-MDIX function, you will be able to use either a straight cable or a cross cable.
2. Make sure that the Ethernet cable is connected to the LAN port of the Wi-Fi device.
(Do not connect the cable to the WAN port.)
3. Open the SETUP screen on the RIVAGE PM system.
4. Touch the NETWORK popup button in the CONSOLE STATUS field to open the NETWORK screen.
5. On the FOR STAGEMIX tab, set the STAGEMIX CONNECTIVITY to ENABLE, and then specify the IP address in the IP
address segment for the Wi-Fi access point.
NOTE
You cannot use 192.168.53.xx for the IP address.
6. On the MISC tab in the NETWORK screen, select “EDITOR/STAGEMIX” or “STAGEMIX ONLY” for the
COMMUNICATION QUALITY of the NETWORK connector for StageMix.
When using the RIVAGE PM Editor and StageMix in the same NETWORK connector, select “EDITOR/STAGEMIX.”
NOTE
When using only StageMix, select the “STAGEMIX ONLY” option to reduce the communication load.
When selecting the “EDITOR/STAGEMIX” option, which results in greater communication load and slower performance of StageMix, enable
IGMP Snooping on the Wi-Fi device.
Network switching
You can connect to a network using a wired connection in addition to a wireless connection. A Lightning to USB 3 Camera Adapter (or a USB-
C-USB adapter) and a USB Ethernet Adapter are required to use a wired connection. You can switch between a wireless and wired connection
when offline.
Software requirements
Setup