User Manual
Table Of Contents
- PRECAUTIONS
- Contents
- Introduction
- System Overview
- About Dante
- About Connections
- Part Names & Functions
- Power Supply
- Installing and Removing Optional Cards
- Touch Screen
- Quick Guide
- Basic system configuration
- Installing an optional card
- Setting the Unit ID
- Connecting the devices
- Turning on the power to the RIVAGE PM7 system
- Setting the word clock
- Assigning channels to the TWINLANe network
- Patching the input ports
- Patching the output ports
- Setting the analog gain for HA (Head Amp)
- Sending an input channel signal to the STEREO bus
- Check list
- Other Operations
- Troubleshooting
- Specifications
- Index
RIVAGE PM7 System Setup Guide
51
Control I/O characteristics
Dimensions (WxHxD), weight
1549 mm × 417 mm × 848 mm (including the rubber feet), 94 kg
Accessories
System Setup Guide, AC power cords ×2, Dust cover, Gooseneck Lamps LA1L ×4
Optional items
Mini-YGDAI card, HY card
Fader
Touch-sensitive 100mm motorized faders; resolution +10 dB to –138 dB, –∞ dB (1024 steps)
NC value
Low mode: NC=20 / High mode: NC=25
Measuring position: 30cm horizontally away and vertically up from the unit (front pad),
Terminal Format Level Connector
WORD CLOCK
IN — TTL/75Ω terminated BNC
OUT — TTL/75Ω BNC
MIDI
IN MIDI — DIN 5pin
OUT MIDI — DIN 5pin
TC IN SMPTE SMPTE 0.3Vpp(min)/10.0Vpp(max), 10kΩ XLR-3-31 type
*7
USB 1-4 USB 2.0 Host USB USB A (Female)
RECORDING
*1
*1. Supported file formats are WAV and MP3.
USB 2.0 Host USB USB A (Female)
VIDEO OUT — DVI-D DVI
NETWORK IEEE802.3 10BASE-T/100BASE-TX etherCON CAT5
*2
*3
*2. CAT5 or higher cables are used for connections.
*3. STP cables are recommended for connections.
NETWORK [PC] IEEE802.3 10BASE-T/100BASE-TX etherCON CAT5
*2 *3
CONSOLE NETWORK IN/OUT — 1000BASE-T etherCON CAT5e
*3 *4
*4. CAT5e or higher cables are used for connections.
GPI
*5
*5. Input pin
CH 1-7: TTL level (input voltage 0-5 V)
CH 8: Photo coupler (input voltage 0-24 V, low level: 1 V or lower, high level: 5 V or higher)
Output pin
CH 1-7: Open drain output (max. supply voltage 12 V, max. sink current/pin 75 mA)
CH 8: Relay contact (max. 1A/30VDC)
Power supply pin
Output voltage 5 V ±5%, max. output current 600 mA
— — D-SUB (25-pin, female)
LAMP 1-4 — 0 V–12 V XLR-4-31 type
*6
*6. 4-pin=+12 V, 3-pin=GND; Up to 5 W is supported for lamp rating.
*7. 1=GND, 2=HOT, 3=COLD, Balanced