User Manual
Table Of Contents
- Contents
- PORT NAME
- Improved CH COPY operation
- More metering points available
- DaNSe
- MIX TO INPUT
- SUB IN
- Improved channel name indicators
- Improved scene operations
- Improved DCA operations
- Improved setting operations in the CUSTOM FADER BANK popup window
- Improved sync operations
- Warning against loading a conflicting system configuration
- Increased loadable items
- Improved EQ functions
- Additional options for the parameter set and copy function
- Additional library screen function
- DSP latency display
- Improved RTA display
- Flashing ON buttons
- [ON] KEYS FUNCTION DURING SOF
- A new [SHIFT] key function
- Improved keyboard input
- Improved RIVAGE PM Editor
- New functions added to the USER DEFINED keys, USER DEFINED knobs, and [Fn] keys
- New messages
CONTENTS
DaNSe
11 RIVAGE PM series V3 Supplemental Manual
;
DaNSe is a powerful, intuitive Dynamic Noise Suppressor designed by the legendary Dr. K’s Labs to
feature exceptional sound quality. This innovative new algorithm can learn the noise characteristics
of an audio signal, and then automatically remove the noise. The controls on the GUI are user-
friendly and easy to learn. Enhanced graphics allow the user to fine-tune and edit the filters in real
time to reduce even the most difficult noises.
Using DaNSe can enhance podium, lavaliers and various microphones in spoken word situations
where the stage environment may have fan noise from moving lights or LED video screens. It can
also be used in theatrical uses to reduce various ‘room tones’ thereby increasing speech intelligibility
and gain before feedback.
1 LOW FREQUENCY knob
Adjusts the lowest frequency value of the noise band that you wish to suppress.
You cannot set a value higher than one quarter of the HIGH FREQUENCY knob setting.
Since this setting is used during analysis by the LEARN function, you must adjust this value
before using the LEARN function.
2 HIGH FREQUENCY knob
Adjusts the highest frequency value of the noise band that you wish to suppress.
You cannot set a value that is lower than the LOW FREQUENCY knob setting multiplied by
four.
Since this setting is used during analysis by the LEARN function, you must adjust this value
before using the LEARN function.
3 LEARN button
Activates the LEARN function. Once the LEARN function starts, it will analyze the input
signal for 10 seconds, and then automatically adjust the THRESHOLD, GAIN 1–6, and the
internal signal processing parameter settings, to achieve the optimal noise suppression effects
that would be suitable for the environment and situation.
After the LEARN operation is complete, adjust the THRESHOLD and TIGHTNESS settings to
your taste to achieve a more ideal sound quality.
To interrupt the LEARN operation, press the LEARN button again or close the GUI.
* The effect of the LEARN operation may vary depending on the environment, even if you adjust
the displayed parameters in the same way, because the internal signal processing parameters
are automatically adjusted according to the environment.
If the parameters are not configured as a Recall Safe target, recalling a scene or library during
the LEARN operation may lead to a failure of the LEARN analysis.
4 REVERT
Use this button to revert to the settings obtained immediately after the LEARN analysis if you
happen to have adjusted the parameters manually after the LEARN analysis.
This button becomes active after the LEARN operation is complete.
5 TIGHTNESS knob
Adjusts the release time. Turning the knob to the right produces a faster release time.
6 THRESHOLD
Adjusts the threshold for all bands.
7 LINK knob
Simultaneously adjusts the GAIN 1–6 values relatively.
8 GAIN 1–6
Adjusts the maximum gain reduction amount for BANDs 1–6.
DaNSe
8
3
4
5
7
6
1 2