User Manual

RM Series (RM-CR/RM-CG/RM-TT/RM-WAP) Remote Control Protocol Specifications Version 2.0.0
5
1. Setup
1.1. Connection Procedure
Remote Controller
Network
Switch
Ethernet Ethernet Dante conector
RM-CR/
RM-CG/
RM-TT/
RM-WAP
1.2. Configuring the Remote Controller
RM-CR/RM-CG/RM-TT/RM-WAP can be controlled from an external controller through the Ethernet (Dante) connector
The configuration on the remote controller side for each type of connection is shown below.
Ethernet (NETWORK connector) control
IP Address: Specify the IP address of the RM-CR/RM-CG/RM-TT/RM-WAP
IP Port No.: 49280
1.3. Device Configuration
The setting required on the main unit is the IP address (UNIT ID) setting.
Up to eight remote controller devices can connect simultaneously to one RM-CR/RM-CG/RM-TT/RM-WAP device