User Manual
RM-CR ReferenceîManual
2
In order to use this unit, setup is required. First, connect this unit to peripheral devices, and then perform setup using the Web GUI.
Connecting to peripheral devices
This unit is one of the components of the complete and customizable ADECIA communications solution. Refer to the diagram below to
connect this unit to peripheral devices with LAN cables.
IMPORTANT: There is a DIP switch for specifying settings on the back of each VXL1-16P. Before plugging in LAN cables, set the DIP
switches as shown below. The DIP switch settings on the two units must not be the same.
SETUP
RM-CG
SWR2311P-10G
RM-CR
VXL1-16P
1st unit 2nd unit