User Manual
Table Of Contents
- RM Series (RM-CR/RM-CG/RM-TT) Remote Control Protocol Specifications
- 0. Revision History
- 1. Setup
- 2. Command List
- 3. Command Specifications
- 4. Command Sequence
- 5. Meter Value
- 6. Parameter Value Details
- 7. Parameter List
- 8. Meter List
RM Series (RM-CR/RM-CG/RM-TT) Remote Control Protocol Specications Version 1.1.0
5
1. Setup
1.1. Connection Procedure
Remote Controller
Network
Switch
Ethernet Ethernet Dante conector
RM-CR/
RM-CG/
RM-TT
1.2. Conguring the Remote Controller
RM-CR/RM-CG/RM-TT can be controlled from an external controller through the Ethernet (Dante) connector
The conguration on the remote controller side for each type of connection is shown below.
Ethernet (NETWORK connector) control
IP Address: Specify the IP address of the RM-CR/RM-CG/RM-TT
IP Port No.: 49280
1.3. Device Conguration
The setting required on the main unit is the IP address (UNIT ID) setting.
Up to eight remote controller devices can connect simultaneously to one RM-CR/RM-CG/RM-TT device