User Manual

Appendix

1. Installing Optional Equipment

RS7000 277

4. Plug in the ﬂat cable backward.

• Disconnect the ﬂat cable.

• Insert the opposite plug into the connector.

The connector has a cut-out that prevents it from being connected in an incorrect orientation.

5. Connect the ﬂat cable.

• Connect the ﬂat cable from the I/O expansion board (the thin, ﬂat cable) to the corresponding connector on the RS7000’s circuit

board (marked “C” in the illustration below: CN16).

The connector is “keyed” so that it will only go in one way.

6. Insert the AIEB2 I/O expansion board.

• Support the I/O expansion board as shown in the illustration below, and fasten it to the rear panel by screwing in the three screws

(B) that you removed at Step 3 above.

I/O cover

(B)

CN 16

(B)