Owner`s manual
Table Of Contents
- Machine Identification
- Introduction
- Contents
- Yamaha Motor Corporation, USA Snowmobile Limited Warranty
- Yamaha Extended Service (Y.E.S.)
- Location of the Important Labels
- Safety Information
- Description
- Control Functions
- Pre-Operation Checks
- Operation
- Periodic Maintenance
- Troubleshooting
- Storage
- Specifications
- Wiring Diagram
7-9
ESU00347
Driving
WARNING
@
Be sure to read the “SAFETY INFORMATION” and
“Riding your snowmobile” sections carefully before
operating the snowmobile.
@
NOTE:
@
Make sure that the engine is warmed up enough before
riding.
@
For RS90/RS90M
1. Release the parking brake by moving the parking
brake lever to the right.
2. Press the throttle lever slowly to move the snowmo-
bile.
3. Turn the handlebar in the desired direction.
4. Squeeze the brake lever to stop the snowmobile.
5. Apply the parking brake by moving the parking brake
lever to the left.
For RS90R/RSG90
1. To select the desired operating position, pull the shift
lever out, slide it to “FWD” or to “REV” until it stops,
and then release it.
1
Pull out
2
Slide to “FWD” (Forward)
3
Slide to “REV” (Reverse)
4
Release
WARNING
@
●
Make sure that the throttle lever is fully released
and the snowmobile is at a full stop before shift-
ing.
●
Be sure to slide the shift lever to “FWD” or “REV”
until it stops completely and only while the
engine is idling.
●
Make sure that the area behind the snowmobile is
clear before reversing. Watch behind.
●
Reduce speed and avoid sharp turning when
operating the snowmobile in reverse.
@
U8ES10.book Page 9 Monday, April 12, 2004 1:25 PM