User Manual

RUio16-D Technical Specifications 1
General Specifications / Caractéristiques générales / 常规规格 /
一般規格 / 一般仕様
Technical Specifications / Caractéristiques techniques / 技术规格 /
技術規格 / 技術仕様
At the time of measurement, all levels are set to nominal. Output impedance of the signal generator is 150 Ω.
0 dBu is referenced to 0.775 Vrms.
Frequency response @ 20 Hz – 20 kHz, reference to the nominal output level @ 1 kHz
Total harmonic distortion
* Total Harmonic Distortion is measured with 22 kHz low pass filter.
Hum & noise
* Hum & noise is measured with A-weighting filter equivalent to a 20 kHz filter with infinite dB/octave attenuation.
* EIN = Equivalent Input Noise
Dynamic range
* Dynamic range is measured with A-weighting filter equivalent to a 20 kHz filter with infinite dB/octave attenuation.
Crosstalk @ 1 kHz
* Crosstalk is measured with a 30 dB/oct filter @ 22 kHz.
Local connectors Analog inputs
2 Mic / Line (XLR)
Analog outputs
2 (XLR)
Phones output
1 (TRS Phone)
Dante I/O
2 (etherCON: Primary / Secondary)
USB 2.0 (PC)
1 (USB Type-C)
DC power input
1 (USB Type-C)
Sampling frequency
44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz
Signal delay
Less than 250 µs, Analog INPUT to Analog OUTPUT @Fs = 96 kHz Bypass USB mode
Power requirements
5 V / 1.5 A
Power consumption
7.5 W
Dimensions W × H × D
180 (W) × 42 (H) × 121 (D) mm (without rubber feet)
Weight
1.0 kg
Operating temperature range
0 – 40°C
Storage temperature range
-20 – 60°C
Included accessories
USB 2.0 Cable (Type-A to Type-C, 1.5 m)
USB 2.0 Cable (Type-C to Type-C, 1.5 m)
Cable hook
Rubber feet
Owner’s Manual
VST Rack Pro Download Information
Input Output RL Conditions Min. Typ. Max. Unit
INPUT 15, 16 OUTPUT 15, 16 10 kΩ Gain: max, PAD: off -1.5 0.0 +1.0 dB
Input Output RL Conditions Min. Typ. Max. Unit
INPUT 15, 16 OUTPUT 15, 16 10 kΩ +4 dBu @ 20 Hz – 20 kHz,
Gain: min, PAD: on
– – 0.02 %
INPUT 15, 16 PHONES 40 Ω 100 mW (Max.before clip level) @ 1 kHz,
Gain: min, PAD: off
– – 0.05 %
Input Output RL Conditions Min. Typ. Max. Unit
INPUT 15, 16 OUTPUT 15, 16 10 kΩ Rs = 150 Ω, Gain: max, PAD: off – -128
EIN
– dBu
– -64
NOISE
– dBu
– OUTPUT 15, 16 10 kΩ Residual output noise, output level control min. – -95 – dBu
– PHONES 40 Ω Residual output noise, phones level control min. – -102 – dBu
Input Output RL Conditions Min. Typ. Max. Unit
INPUT 15, 16 OUTPUT 15, 16 10 kΩ AD + DA, Gain: min, PAD: on – 110 – dB
DA Converter – 118 – dB
From / To To / From Conditions Min. Typ. Max. Unit
INPUT 15/16 INPUT 16/15 Gain: min (INPUT 15) → Gain: min (INPUT 16)
Gain: min (INPUT 16) → Gain: min (INPUT 15)
– – -100 dB
Gain: max (INPUT 15) → Gain: max (INPUT 16)
Gain: max (INPUT 16) → Gain: max (INPUT 15)
– – -80 dB
Gain: min (INPUT 15) → Gain: max (INPUT 16)
Gain: min (INPUT 16) → Gain: max (INPUT 15)
– – -80 dB
AUDIO INTERFACE / INTERFACE AUDIO /
INTERFAZ DE AUDIO / АУДИОИНТЕРФЕЙС /
갉곸歲꬗
킮쪎핳󼯇
؛٭ظؔ؛ؕ٤ذ٭نؘ٭ت
TECHNICAL SPECIFICATIONS