Owner`s manual

8-27
ESU00292
Control rod adjustment
The weight transfer can be adjusted by turning the con-
trol rod adjusting nut
1
.
1. Loosen the locknut
2
while holding the control rod
adjusting nut
1
.
2. To increase weight transfer, turn the adjusting nut in
direction
a
. To decrease weight transfer, turn the
adjusting nut in direction
b
.
3. Tighten the locknut.
CAUTION
:
@
●
When using the two 22-mm wrenches included in the
tool kit, make sure that they are situated at a right
angle to the control rod as shown, and that they are
tightly fitted to the locknut and the control rod adjust-
ing nut.
●
The left and right adjusting nuts must be set to the
same position. Uneven settings can cause poor han-
dling and loss of stability.
@
WARNING
@
Never adjust the control rods beyond the maximum
range indicated on the rods with red paint 3.
@
c
Adjustable range
d
Standard position
Locknut tightening torque:
25 Nm (2.5 m·kgf, 18.1 ft·lb)
U8FA11.book Page 27 Thursday, April 3, 2003 4:09 PM