Owner`s manual

8-31
2. Loosen the handlebar bolts.
3. Move the handlebar up or down (
±
7°) to adjust the
handlebar height to the desired position.
È
RX10/RX10S/RX10R/RX10RS/RXW10/RXW10S
É
RX10M/RX10MS
CAUTION
:
@
Make sure that the projection on the handlebar is not
installed into the area a shown.
@
4. Tighten the handlebar bolts and install the handlebar
cover.
CAUTION
:
@
Make sure that the small gap b side of the handlebar
holders faces forward c.
@
A
B
Handlebar bolt tightening torque:
14.5 Nm (1.45 m·kgf, 10.5 ft·lb)
U8FA11.book Page 31 Thursday, April 3, 2003 4:09 PM